![Top of page](http://au.rrforums.net/forum/icons/mark_top.gif) ![Previous message](http://au.rrforums.net/forum/icons/mark_up.gif) ![Next message](http://au.rrforums.net/forum/icons/mark_down.gif) ![Link to this message](http://au.rrforums.net/forum/icons/tree_m.gif)
Brian Vogel
Prolific User Username: guyslp
Post Number: 279 Registered: 6-2009
| Posted on Sunday, 10 March, 2013 - 11:41: | ![Edit Post](http://au.rrforums.net/forum/icons/tree_s.gif) ![Delete Post](http://au.rrforums.net/forum/icons/delmsg.gif) ![View Post/Check IP](http://au.rrforums.net/forum/icons/checkip.gif) |
Vladimir, The o-rings, etc., for RR363 systems are all EPDM (70 durometer) and are all standard sizes (which is unsurprising - one engineers around commonly available seal sizes). I have documented a number of these in this document. I acquired the vast majority of these o-rings when I needed them from Amazon Supply. I eventually hope that the mission I started on to document the comprehensive set of seals and other rubber bits in the brake hydraulic system will be completed. However, that will occur either as I need to tear apart specific things for repair or when "friends with kits" send them to me prior to installing them so I can document their contents. Brian |