| Author | Message | ||
     michael vass Frequent User Username: mikebentleyturbo2 Post Number: 577 Registered: 07-2015 |
Hi All Thanks from the info on here from Stefan Morely and Richard Treacy and all the other contributors ! I have modded my turbo boost system similar to how they advised. see pic  The driver I have used is this ebay item 392094365178 With a 200 ohm load resistor. Now get the proper 6.2 psi boost reliably. Next mod is the boost fooler pot!! Thanks for all the contributors on previous posts on this subject! Cheers Mike | ||
| Mark Luft Frequent User Username: bentleyman1993 Post Number: 289 Registered: 10-2016 |
Great news Mike! I too wish to mod my turbo. How does it work? Do you FEEL a difference? | ||
| Mark Luft Frequent User Username: bentleyman1993 Post Number: 290 Registered: 10-2016 |
I can't find the listing. Could you post a link? | ||
| michael vass Frequent User Username: mikebentleyturbo2 Post Number: 579 Registered: 07-2015 |
Hi Mark Just moving the solenoid from on top of a hot engine and cleaning out makes the thing more reliable, the driver was to give the boost ecu an easier life than driving inductive loads ok here is a link https://www.ebay.co.uk/itm/12V-Input-Optocoupler-Isolation-Module-Solenoid-Valve-Relay-5-12-24V-Output-/392094365178 Here is a basic diagram of how I used it ok I have't have much chance to drive it yet but will be going to Blenheim for the Bentley day so will see then! Cheers Mike  |
