Turbo R boot lock part replacement Log Out | Topics | Search
Moderators | Register | Edit Profile

Australian RR Forums » Spirit Series » Threads to 2015 » Turbo R boot lock part replacement « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Bill Lillios
New User
Username: blillios

Post Number: 3
Registered: 8-2013
Posted on Wednesday, 25 September, 2013 - 07:28:   Edit PostDelete PostView Post/Check IP

I have discovered that a small plastic lever on the back of the lock cylinder of my 96 Turbo RL's boot lid has broken. The part number is UB85381. I need helping figuring out how to replace this part. My initial attempt was to remove the cylinder but after releasing the clip that holds it in place it still wont budge. Has anyone had to replace this and how did you do it. I have the part diagram and I've considered removing the whole mechanism and the plates that hold it, but I wanted to check before taken this on.

Bill
Top of pagePrevious messageNext messageBottom of page Link to this message

Paul Yorke
Grand Master
Username: paul_yorke

Post Number: 1125
Registered: 6-2006
Posted on Wednesday, 25 September, 2013 - 08:48:   Edit PostDelete PostView Post/Check IP

Hi Bill,

It's a fiddle. but easier when out on your desk.

Unclip the rod and electrical connection and then undo the two 7/16 nuts and bolts and it should wiggle out towards you

Of course it sounds easy . .

Once out . . more fiddling.



Good luck.