Flasher Unit Log Out | Topics | Search
Moderators | Register | Edit Profile

Australian RR Forums » Silver Shadow Series » Threads to 2015 » Flasher Unit « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Ben crombie
New User
Username: crombo97

Post Number: 3
Registered: 9-2006
Posted on Wednesday, 04 October, 2006 - 04:03 pm:   Edit PostDelete PostView Post/Check IP

My indicators on my 68 SS have stoped flashing
They just stay on constantly while the switch is on
Where abouts is the Flasher in a Silver Shadow
Thanks
Ben
Top of pagePrevious messageNext messageBottom of page Link to this message

Richard Treacy
Grand Master
Username: richard_treacy

Post Number: 1090
Registered: 4-2003
Posted on Wednesday, 04 October, 2006 - 07:39 pm:   Edit PostDelete PostView Post/Check IP

Go to the technical library on this site and look up your car. Under the electrical section:

http://au.rrforums.net/forum/messages/3309/M_Electrical_System-5093.pdf

dial up page 63 and you will see that the flasher is on the fuse panel by the steering column under the dashboard.

<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
Quote:
Direction indicator (flasher) unit
-To maintain
Flasher units are sealed during manufacture, therefore a defective unit must be renewed.
The unit is fitted to the fuse panel (distribution board) adjacent to the steering column (see Section M2 - Fuse panel) and is fitted directly into the printed circuit.

Fault diagnosis
In the event of a fault occuring in the direction indicator system, the following procedure should be used.
1. Check all indicator bulbs for broken filaments.
2. Refer to main wiring diagram and check all indicator circuit connections.
3. Switch on the ignition.
4. Using a voltmeter, check that 12 Volts is available at the flasher unit terminal marked 'B'.
Flasher unit renewal
1. Remove from the fuse panel (see Section M2) and fit the new unit.
Note Flasher units must be handled with care
Top of pagePrevious messageNext messageBottom of page Link to this message

whunter
Prolific User
Username: whunter

Post Number: 179
Registered: 10-2003
Posted on Thursday, 05 October, 2006 - 12:35 am:   Edit PostDelete PostView Post/Check IP

Hello Ben crombie
If the issue is that both turn signals light and stay on.
There are two possible causes:
#1. Issue in your hazard light circuit.
#2. Three wires shorting together.