Silver Shadow Carb Air Horns: Install Log Out | Topics | Search
Moderators | Register | Edit Profile

Australian RR Forums » Silver Shadow Series » Threads to 2015 » Silver Shadow Carb Air Horns: Install « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Randy Roberson
Prolific User
Username: wascator

Post Number: 222
Registered: 5-2009
Posted on Friday, 30 May, 2014 - 12:28 pm:   Edit PostDelete PostView Post/Check IP
Hi. Ok I need you guys yet again. I dismantled my carb assembly to paint the air horns and center tee. I got new seal rings (o rings) for the air horn-tee joint, and included in the kit was a "tool" to install the air horns in the tee. It is simply a somewhat stiff plastic strip, which I assume is used to slip the end of the air horn past the new O rings. Trouble is, the joint is so tight I can't get the strip out of the joint after I struggle it together.
Top of pagePrevious messageNext messageBottom of page Link to this message

Nigel Johnson
Prolific User
Username: nigel_johnson

Post Number: 124
Registered: 12-2008
Posted on Friday, 30 May, 2014 - 07:04 pm:   Edit PostDelete PostView Post/Check IP
A touch of rubber grease perhaps?
Regards, Nigel.
Top of pagePrevious messageNext messageBottom of page Link to this message

Randy Roberson
Prolific User
Username: wascator

Post Number: 223
Registered: 5-2009
Posted on Friday, 30 May, 2014 - 09:58 pm:   Edit PostDelete PostView Post/Check IP
Well, yes, but that did not seem to do the trick. I am going to try some shim stock next.