Post Number: 132
|Posted on Saturday, 24 April, 2004 - 18:19: |
Can I resurect the above post now 2 1/2 years old. Given the number of Clouds and Bentleys in this country I am amazed this problem has not confounded someone else.
Posted From: 220.127.116.11
|Posted on Sunday, 25 April, 2004 - 10:45: |
Dear Bill, I have assisted the restoration of an S3 here in Melbourne; said vehicle now fitted with a modern U.S system, as the original was beyond economic repair. I feel sure that I have seen the part to which you refer and MAY even have a spare surplus to this project. I respond better to pictures/illus. or even a line drawing in order to i.d positively. Can you please e-mail something to me .. john.dares@bigpond. I will try to assist. Rgds
Post Number: 135
|Posted on Sunday, 25 April, 2004 - 15:26: |
John Many thanks. The picture of it in situ is on page 36 of Tee One Topics for August 2001. But have you got a CD of the back issue. If not I'll send you one. The cross section by the way is omega which I seem to have left off the original. I'll send you a copy of the pic in the meantime!
Post Number: 11
|Posted on Friday, 14 December, 2007 - 06:18: |
At the risk of overkill, these people will make all you want: http://www.usrubberco.com/index.html
|Posted on Sunday, 05 August, 2001 - 11:07: |
As part of a general overhaul of my S2 I removed the underwing air conditionng assembly. The air return duct at the lower rear end of the unit joins up with the ducting that starts under and beside the driver's seat (RHD). To join the two ducts at a point just ahead of the right hand front body mounting outrigger, the factory used a rubber joiner/seal which had an 'omega' shaped cross section to allow for movement of the relevant bits.
Curiously I have found no reference to this in the parts manual neither is it shown. The rubber tends to perish on the low side of the seal allowing dust and ambient air to get into the system. Professional advice is to use a suitable section of truck inner tube but I would like to avoid this in the interests of originality.
Can anybody help please. Failing that can someone provide a suitable entree/address to the Factory supply system as I have tried using dealers and given the trivial nature of the part it seems not to be worth their while to chase through the system.