| Author | Message | ||
     Nigel Parker Experienced User Username: trawler Post Number: 49 Registered: 9-2011 |
OK I am a complete numpty,but trying to remove the seat cushions on the front seats to access the seat ECU's on my 96 Turbo R has me stumped and have downloaded the info but apart from removing the seat back cannot seem to find anyway of removing the seat cushion............Any help appreciated. I have removed the ECU's although some skin missing from knuckles.....However would appreciate a easier refittment when repaired......Thks in advance.Brgds Nigel | ||
| Paul Yorke Grand Master Username: paul_yorke Post Number: 1094 Registered: 6-2006 |
Hi Nigel, I think yours should have two push fit pegs at the front edge of the cushions. Pull the squab leaving the surround around the base in position. With the back off, were there two screws exposed near the site of the two you need to remove to get the back off? If you have non sports / earlier seats for some reason - Check for metal claws on rubber straps running from front to rear clipping over the seat frame bars. | ||
| Nigel Parker Experienced User Username: trawler Post Number: 50 Registered: 9-2011 |
Thks Paul,did not see the other 2 screws after the seat back removed.Only 1 screw on the outer side to remove seat back with velcro on the inside.Also unable to find any metal claws/rubber straps from front to rear clipping over seat frame bars.Cheers | ||
| Paul Yorke Grand Master Username: paul_yorke Post Number: 1096 Registered: 6-2006 |
I think yours are the later type and push fit at the front. pulling the front of the piece your rear goes on upwards should pop it out. I think I'm doing one early next week. will try to take photos for you. | ||
| Nigel Parker Frequent User Username: trawler Post Number: 52 Registered: 9-2011 |
Thks Paul |
